Dryside Island Inflatable Set Up and Care

Dryside Island Float – Setup & Deflation Guide

Inflation

1. Lay out the float
   Place the float on a flat, dry surface with the backrest facing up.
2. Open access flaps
   Locate and open the two rear flaps:
   • One for the seat chamber (bottom)
   • One for the backrest chamber (top)
3. Open the valve
   Pull the tab on the transparent plug to open.
   Do not remove the black valve during inflation.
4. Inflate the chamber
   Insert the pump nozzle into the valve and inflate to a firm, comfortable level.
5. Seal the valve
   Remove the pump and firmly press the transparent plug back into place. Close the flap.
6. Repeat
   Inflate the second chamber following the same steps.

Deflation

1. Open access flaps
   Expose both valves by opening the rear flaps.
2. Open valves fully
   Remove both the transparent plug and black valve to release air quickly.
3. Release air
   Gently press on the float to push air out. Avoid twisting or excessive force.
4. Prepare for storage
   Reinsert the black valve and transparent plug after deflation.

Tips

• Use an air pump for best results
• Do not overinflate
• Ensure the float is dry before storing
• Weight Limit: 500 lbs.

Step-by-step with photos: